Table of Contents
Advertisement
B. OPERATING INSTRUCTIONS
CONTROL PANEL
RUN
Indicator light illuminates to signify the cooling mode is currently in
operation
LIGHT
To turn on/ off the inner light
POWER
To switch on/ off the appliance
UP
To raise the temperature by 1℃
DOWN
To lower the temperature by 1℃
DISPLAY
To indicate the temperature of the internal cabinet
TEMP. SET
To indicate the setting temperature
TEMPERATURE SETTING
• Connect the power cord to a properly grounded outlet. In the event of a power
interruption, all previous temperature settings will be automatically erased and it
will default to a preset temperature setting of 12℃.
• Set the desired cooling temperature by pressing the "UP/DOWN" buttons. The
temperature selected will flash in the LED display for approximately 5 seconds,
then revert back to display the temperature of the internal cabinet
• The temperature setting can be adjusted from 5℃ to 18℃ .
REMOVING SHELVES
Attention:
To prevent damaging the door gasket, make sure to have the door all the way
opened when pulling shelves out of the rail compartment.
For easy access to the storage content, you must pull the shelves approximately
1/3 out of the rail compartment, however this unit was designed with a notch on
each sides of the shelf tracks to prevent bottles from falling.
To fit or remove the shelf, tilt the shelf as below diagram and simply pull out or push
into the shelf until it sits on the support brackets securely.
4
Advertisement
Table of Contents
