Page 3
INDEX Diagram Characteristics of the appliances Technical data 4 Installation instructions 4.1 Safety rules 4.2 Structure, framework and safety devices of the appliances 4.3 Assembly 4.3.1 Installation premises 4.3.2 Statutory regulations and technical requirements 4.3.3 Installation 4.3.4 Electrical connection 4.3.5 Equipotential Operation preparation 5.1 Preparation and Start-up 5.1.1 Start-up...
Page 4
1 - DIAGRAM ADN 642 Electric power Data plate Electric power Data plate ADN 657 Electric power Data plate Electric power Data plate 0809_GB_42 - ELECTRIC BAIN-MARIE 04/2008 4 · 12...
THE APPLIANCE MUST BE INSTALLED BY QUALIFIED PERSONNEL. 3 - TECHNICAL DATA Model Description Dimensions in mm. (LxDxH) N˚ Tank Capacity ADN 657 Electric bain-marie 400 x 600 x 270 GN 1/1 h 15 / 23 l ADN 642 Electric bain-marie 400 x 700 x 900...
4 - INSTALLATION INSTRUCTIONS 4.1 Safety rules 4.3.2 Statutory regulations and technical requirements During installation of the appliance, the following regulations must • Only a local gas utility technician is authorized to carry out gas be adhered to: installations and connections. The statutory regulations (applied •...
5 - SET-UP FOR OPERATION 5.1 Preparation and Start-up 5.3 Replacing parts All parts must be replaced by authorized technicians only! Before starting up the appliance, remove the protective wrapping. To replace the following parts first remove all the control knobs and Then carefully clean the working surface and the external parts with control panel (after loosening the fixing screws), then extract the lukewarm water and detergent, using a damp rag to remove all traces...
Page 8
6 - INSTRUCTIONS FOR USE 6.4 Turning the appliance off in case of Fig. 1 breakdown 6.4.1 What to do in case of failure In case of breakdown or malfunctioning or failure turn off the appliance. Switch off any electric power. Call the service centre. 6.4.2 What to do in case of prolonged period of disuse When the appliance is not to be used for a long time, clean thor- oughly, cas instructed in the chapter 6.5 “Appliance care and fre-...
Page 9
6 - INSTRUCTIONS FOR USE • outside rust (i.e. from other components, tools or incipient rust) • iron particles (i.e. file dust) • contact with non-ferrous metals (element build up) • lack of oxygen (i.e. no air inlet, water lacking oxygen). 6.6.2 Warnings and advice for maintenance of “stain- less steel”...
Page 10
6 - INSTRUCTIONS FOR USE 6.6.3 The 2002/96/EC (WEEE) Directive: information to users This informational note is meant only Fig. A for owners of equipment marked with the symbol shown in fig. A on the adhe- sive label featuring the technical specifi- cations applied on the actual product (the label also giving the serial number).
7 - APPENDIX: ELECTRICAL DIAGRAMS ADN 657 ADN 642 L1 N PE Terminal board Switch Thermostat Yellow indicator light Heating element 1000 W Total power: 1.0 kW 0809_GB_42 - ELECTRIC BAIN-MARIE 04/2008 11 · 12...
Page 12
THE MANUFACTURER RESERVES THE RIGHT TO MAKE ANY CHANGES DEEMED NECESSARY. THE MANUFACTURER CANNOT BE HELD RESPONSIBLE IF THE INSTRUCTIONS CONTAINED IN THIS MANUAL ARE NOT OBSERVED. WHIRLPOOL EUROPE srl V.le Guido Borghi, 27 I – 21025 Comerio – VA...
Need help?
Do you have a question about the ADN 657 and is the answer not in the manual?
Questions and answers