Important Instructions; Cleaning And Maintenance - Remington HAIR Envy GLAMOUR MULTI STYLER KIT Manual

ENGLISH
TO CHANGE THE STRAIGHTENING/CRIMPING PLATES
• Ensure the unit is switched off and cool.
• Slide the plates out holding the plastic edges.
• Turn the plates over and slot back into place.
TO SECURE ATTACHMENT TO HANDLE
• Ensure the locking ring is in the unlocked position, ready to insert the attachment.
• Firmly push together. (DIAGRAM 2)
• Turn the locking ring anti-clockwise to secure the handle and the attachment together,
Plug in the unit and switch on, the first green LED indicator light will start flashing.
NOTE:The unit will not turn on unless the attachment is inserted correctly.
Select the desired temperature. To change the temperature, use the '+' or '-' buttons
to increase or decrease the temperature. The LED lights will flash until your desired
temperature has been reached. After use switch the unit off.
For finer hair types a lower temperature is recommended.
Due to the extreme heat capabilities of this styler, extra care should be taken when
using.
While heating, during use and cooling, place on flat, smooth, heat-resistant surface. Only
hold unit at the end of the handle.
Please note regular use of styling products may deteriorate the coating.
Do not scratch the surface, as this will deteriorate the effectiveness of the coating.
Ensure the unit is unplugged and cool. Wipe clean any build up of styling products with a
damp cloth. Do not use an abrasive cleaning fluid to clean, as damage will occur.
2
080225_REM_IFU_S8670 21L+HE.indd GB_2 080225_REM_IFU_S8670 21L+HE.indd GB_2
Locate the pins on the attachment and holes on the handle. (DIAGRAM 1)
while still pressing down on the attachment (DIAGRAM 3).

IMPORTANT INSTRUCTIONS

CLEANING AND MAINTENANCE

21.04.2008 12:03:18 Uhr 21.04.2008 12:03:18 Uhr