Craftsman 580.752872 Operator's Manual page 14

Table of Contents

Advertisement

Available languages

Available languages

How to Use Accessory Tray
The unit is equipped with an accessory tray with
places to store your spray gun, nozzle extension, high
pressure hose and quick connect spray tips.
1. Place spray gun in wide groove on accessory tray
as shown. Pull rubber strap tight around spray gun
and place hole in strap over tab on accessory tray.
2. Place nozzle extension in narrow groove on
accessory tray. Pull rubber strap tight around
nozzle extension and place hole in strap over tab
on accessory tray.
3. Insert multi–colored spray tips in holes provided on
front of accessory tray.
4. Place one end of high pressure hose in groove at
top of accessory tray and wrap high pressure hose
around hooks as shown.
How to Use Spray Tips
The quick–connect on the nozzle extension allows you
to switch between four different quick connect spray
tips. Spray tips can be changed while pressure washer
is running once spray gun trigger is locked. The spray
tips vary the spray pattern as shown.
Follow these instructions to change spray tips:
1. Pull back collar on quick–connect and pull current
spray tip off. Store spray tips in holder provided on
the accessory tray.
WARNING The high pressure stream of water
that this equipment produces could cut
through skin and its underlying tissues,
resulting in serious injury and possible
amputation.
• NEVER change spray tips without the trigger locked on
the spray gun.
• DO NOT twist spray tips while spraying.
2. Select desired spray tip:
High Pressure
40° White
2100 PSI
2.3 GPM
For delicate rinse (lower pressure and higher
flow), for gentle cleaning of cars/trucks, boats,
RV's, patio furniture, lawn equipment, etc.,
select white 40° spray tip.
For general rinsing (medium pressure and
medium flow), ideal for most all purpose
cleaning such as home siding, brick patios,
wood decks, driveways and sidewalks, garage
floors, etc., select yellow 15° spray tip.
For maximum rinsing (higher pressure and
lower flow), for stubborn or hard to reach
surface such as second story surfaces, paint
removal, oil stains, rust removal or other
stubborn substances (tar, gum, grease, wax,
etc.), select red 0° spray tip.
To apply detergent, applies project specific
cleaners to help break down stubborn dirt and
grime on a variety of surfaces, select black
detergent spray tip.
3. Pull back on collar, insert new spray tip and release
collar. Tug on spray tip to make sure it is securely
in place.
Usage Tips
• For most effective cleaning, keep spray tip from
8 to 24 inches (20 to 61 cm) away from cleaning
surface.
• If you get spray tip too close, especially using a high
pressure spray tip, you may damage surface being
cleaned.
• Do Not get closer than 6 inches (15 cm) when
cleaning tires.
14
Low Pressure
Black
Use to apply
detergent
15° Yellow
0° Red
2300 PSI
2700 PSI
2.2 GPM
2.1 GPM

Hide quick links:

Advertisement

Chapters

Table of Contents
loading

Table of Contents