Broan ERV100S User Manual

Broan ERV100S User Manual

Hide thumbs Also See for ERV100S:

Advertisement

Quick Links

USER GUIDE FOR
BROAN ERV100S AND ERV100SP
VB0198
VB0197
Model ERV100S
Model ERV100SP*
*This product earned the ENERGY STAR
®
by meeting strict energy efficiency guidelines set by Natural Resources Canada and the
US EPA. They meet ENERGY STAR requirements only when used in Canada.
RESIDENTIAL USE ONLY
!
!
READ AND SAVE THESE INSTRUCTIONS
INSTALLER: LEAVE THIS MANUAL WITH HOMEOWNER
Broan-Nutone LLC; Hartford, Wisconsin www.broan.com 877-862-7626
RETGISTER YOUR PRODUCT ONLINE AT: www.broan.com/register
For additional information - visit www.broan.com
22641 rev. 01

Advertisement

Table of Contents
loading

Summary of Contents for Broan ERV100S

  • Page 1 US EPA. They meet ENERGY STAR requirements only when used in Canada. RESIDENTIAL USE ONLY READ AND SAVE THESE INSTRUCTIONS INSTALLER: LEAVE THIS MANUAL WITH HOMEOWNER Broan-Nutone LLC; Hartford, Wisconsin www.broan.com 877-862-7626 RETGISTER YOUR PRODUCT ONLINE AT: www.broan.com/register For additional information - visit www.broan.com 22641 rev. 01...
  • Page 2 Any third party replacement part used may cause serious damage and drastically reduce the performance level of your unit, which will result in premature failing. Broan-Nutone LLC also...
  • Page 3: Table Of Contents

    To maintain its proper operation, the unit is programmed to defrost the energy recovery core. For ERV100S model, during the defrost cycle, the unit keeps the same speed but stops to supply fresh air. For ERV100SP model, during the defrost cycle, the dampers close but the unit speed can be set on high or low, according to your needs.
  • Page 4: Controls

    Once the motorized damper position completely set, the booting sequence is done; the color of the LED will show on which defrost cycle the unit is set. NOTE: No command will be taken until the unit is fully booted. 2.2 ERV100S B OOTING EQUENCE The unit booting sequence is similar to a personal computer booting sequence.
  • Page 5: Erv100Sp Integrated

    UXILIARY ONTROLS The ERV100SP unit must be controlled by a main control. For more convenience, the ERV100S unit can also be controlled using an optional main control. Only one main control can be connected per unit. NOTES: 1. The integrated control must be turned OFF on ERV100S model to use a main control.
  • Page 6: Maintenance

    3. M AINTENANCE WARNING Risk of electric shock. Before performing any maintenance or servicing, always disconnect the unit from its power source. When cleaning the unit, it is recommended to wear safety glasses and gloves. 3.1 Q UARTERLY AINTENANCE 1. Turn off and unplug the unit. IDE LATCHES 2.
  • Page 7: Annual Maintenance

    3. M ’ AINTENANCE CONT 3.1 Q ’ UARTERLY AINTENANCE CONT ILTER LOCATION ILTER LOCATION MAINTENANCE FILTERS NDER NORMAL CONDITIONS FILTERS SHOULD BE WASHED EVERY MONTHS • U SE A VACUUM CLEANER TO REMOVE ACCUMULATED DUST ON THE FILTERS • W ASH FILTERS IN A SOLUTION OF LUKEWARM WATER AND MILD SOAP RINSE...
  • Page 8: Troubleshooting

    ERV100SP unit: Turn off the unit using its main control, reset the unit by unplugging it for one minute and then replug it. ERV100S unit: Turn off the unit using the integrated push-button, reset the unit by unplugging it for one minute and then replug it.

This manual is also suitable for:

Erv100spCfm

Table of Contents