Προετοιμασία; Αφαίρεση Συσκευασίας Της Τηλεόρασης - JVC LT-55K870 Instruction Manual

55" led smart 4k ultra hd tv
Table of Contents

Advertisement

Available languages

Available languages

Κεφάλαιο
2
Προετοιμασία
2
Σας ευχαριστούμε
Η νέα τηλεόρασή σας διαθέτει πολλά χαρακτηριστικά και ενσωματώνει την τελευταία λέξη της τεχνολογίας
για βελτιωμένη εμπειρία τηλεθέασης. Συνιστάται να αφιερώσετε λίγο χρόνο στην ανάγνωση αυτού του
εγχειριδίου οδηγιών προκειμένου να κατανοήσετε πλήρως όλα τα λειτουργικά χαρακτηριστικά που
παρέχονται. Θα βρείτε και κάποιες υποδείξεις και συμβουλές για να μπορέσετε να επιλύσετε κάποιο ζήτημα.
Διαβάστε προσεκτικά όλες τις οδηγίες ασφαλείας πριν χρησιμοποιήσετε τη συσκευή και κρατήστε αυτό το
εγχειρίδιο για μελλοντική αναφορά.
Αφαίρεση συσκευασίας της τηλεόρασης
Αφαιρέστε όλα τα υλικά συσκευασίας από την τηλεόραση. Φυλάξτε τη συσκευασία. Σε περίπτωση απόρριψης, ακολουθήστε τους
κανονισμούς της τοπικής κοινότητας.
Περιλαμβάνονται τα παρακάτω εξαρτήματα:
Τηλεόραση
Κάλυμμα αυχένα βάσης
στήριξης τηλεόρασης και
αυχένας
GB
GR
Instruction Manual
Εγχειρίδιο χρήσης
55" LED Smart 4K Ultra HD TV
LED Smart 4K Ultra HD TV 55 ιντσών
LT-55K870
Εγχειρίδιο χρήσης
JVC 55' LED Smart 4K Ultra HD TV LT-55K870 Manual GR.indd 61
για την αγορά της νέας τηλεόρασης της JVC.
A
B
Βίδες x5
Βίδες x6
Βάση στήριξης
τηλεόρασης
3
Installing the Base Stand
Fitting the Neck and Neck
Cover Together
Quick Start Guide
1. Fit the neck cover over the neck.
2. Using 2 of the supplied screws (A),
screw the neck and neck cover
55" LED Smart 4K Ultra HD TV
together.
A
A
LT-55K870
Fitting the Neck and Stand to the TV
3. Ensure the TV is switched off and not connected to
the mains power supply.
Thank you
for purchasing your new JVC TV.
4. Lay the TV down on a flat surface ideally on the
Your new TV incorporates the latest technology to enhance your viewing
edge of a table so the base of the TV slightly
experience. We would suggest that you allow about 20 mins for initial setup.
overhangs the edge of the table, with the back side
facing up. Please make sure a soft cushioned
Please follow this guide for a successful first time installation.
material (such as a dry bath towel or thick piece of
foam) is placed beneath the screen. You can leave
the protective bag on to protect the TV at this point.
5. Slide the Neck and Neck cover under the lip, the
neck will fit snugly over the screw holes. Then screw
A
the Neck to the TV using the 6 screws (B) supplied.
The latest eco-friendly power-saving technology will switch off the TV if
6. Once the Neck is secure screw the base to the neck
it is left on and idle for 4 hours. Please refer to "Auto Standby" under the
using the 3 screws (A) supplied. Be careful not the
"Time Settings" section of the instruction manual for more detail.
drop the base, its heavy.
The LCD display is very fragile, and must be protected at all times when installing and removing the base stand. Be sure that no hard or sharp object,
1
Unpacking
or anything that could scratch or damage the LCD display, comes into contact with it. DO NOT exert pressure on the front of the TV at any time because
the screen could crack.
Remove all packaging from the unit. Retain the packaging. If you dispose of it please do so according to any local regulations.
4
TV
TV Stand Base
Screws (B) x 6
Connecting the Aerial and Turning on the TV
TV Stand Neck
Remote Control/
Instruction Manual
AAA Batteries x2
TV Stand Neck cover
Quick Start Guide
1. Connect one end of the RF coaxial cable
Optional
Screws (A) x 5
to the aerial socket on the wall and the
other end of the cable to the ANT socket
If you want to connect to the internet via a wired connection then
on the back of your TV.
connect your ethernet cable to the LAN socket.
Please inspect your TV for damage after unpacking. If you do notice any damage please consult your dealer.
2. Plug the TV into a mains socket and
switch on at the mains.
3. In standby mode, press the
button on
the remote control to turn the TV on. The
2
Operating Your Remote Control
LED indicator will flash for a few seconds
then the TV will switch on.
1. Slide open the battery compartment on the back of the remote control.
2. Insert two AAA size batteries. Make sure to match the (+) and ( - )
ends of the batteries with the (+) and ( - ) ends indicated in the battery
compartment.
3. Slide the battery compartment cover back into place. Make sure it clicks
• Do not connect the TV to the mains supply until you have completed all the connections.
into place.
• Always disconnect the TV from the mains socket when not in use for a long period of time.
• The
button on the remote control is only used for switching the TV into standby, it does not disconnect the TV from the mains power.
To completely disconnect the mains power, please remove the mains plug from the mains socket.
JVC 55' LED Smart 4K Ultra HD TV LT-55K870 Quick Start.indd 1
Οδηγός γρήγορης εκκίνησης
2
3
.,/@
ABC
DEF
4
5
6
GHI
JKL
MNO
7
8
9
PQRS
TUV
WXYZ
0
TV
V
P
OK
EPG
TXT
LANG.
SUBT.
Τηλεχειριστήριο/Μπαταρίες
ΑΑΑ x 2
Cushioned
material
Protective
Table
Bag
B
RF coaxial cable
(not included)
11/10/2017 16:17
61
18/10/2017 10:34

Advertisement

Table of Contents
loading

Table of Contents