miseno MNO163219SR5050 Installation Instructions

General Recommendations:

Please read installation and maintenance instructions thoroughly.
Inspect your sink for any noticeable damage before installation.
Check all local applicable plumbing and building codes.
These instructions are based on application to composite material or solid surface countertop installation
only; countertop application to stone, marble, granite or butcher-block should be referred to an
experienced countertop fabricator for custom installation.
Because Miseno Undermount sinks are individually handmade, we suggest using experienced and
professional installers only. For custom cutting of countertop and installation of the actual sink, on-site
installation is also recommended. Acceptable variances are approximately 1/8 of an inch. Alignment to
the cut-out and precise application and trimming of any adhesive sealant are critical to a superior fit and
finished look. Please take extra care in this regard.
Miseno does not accept any liability for damage to countertop, sink fixture, faucets or personal injury
during installation. Warranty is void if installation instructions are not followed.

Tools and Materials needed:

Tape Measure
Scroll Saw / Jigsaw
Rags
Pencil (NOT ink)
Be sure to use proper tools and always wear personal safety devices for your protection.
Contact Miseno at (855) 480-2915 or email infoservice@miseno.com with any questions. Copyright ©2019, Miseno. All rights reserved
MNO163219SR5050
Ear Protection
Denatured Alcohol
Eye Protection
Silicone Adhesive Sealant
Handmade Undermount Sinks
Fine-mesh file or sandpaper
Quick-Setting Epoxy
Drill and bits
Installation Instructions
1