Advertisement
Figure 9
1. Bolts (5/16 x 3/4 inch)
2. Cam bracket
2.
Secure the bracket with 2 bolts (5/16 x 3/4 inch)
and 2 flange nuts (5/16 inch).
3.
Rotate each cam toward the center of the
machine
(Figure
10).
Figure 10
1. Cylindrical end
2. Hole
4.
With each cam, insert the cylindrical end of the
cable into the hole in the cam, and slide the
cable into the slot
5.
Slip one end of a spring into the slot at the
bottom of the cam, and hook the spring onto the
cam as shown in
Figure
3. Flange nuts (5/16 inch)
3. Slot
4. Cable
(Figure
10).
11.
g024656
1. Tab
2. Spring
6.
Hook the other end of the spring over the tab on
the cam bracket
5
Routing and Mounting the
Cables
Parts needed for this procedure:
2
Cable tie
g024659
2
Bolt (5/16 x 3-1/2 inch)
4
Friction washer
2
Spacer (5/16 x 3/8 inch)
2
Spacer (5/16 x 1 inch)
2
Flange nut (5/16 inch)
Procedure
1.
Route each cable from the cam downward under
the control-lever linkage, and then backward
along the frame as shown in
Figure
13.
5
Figure 11
3. Slot
(Figure
11).
Figure 12
g024718
and
Advertisement
