Advertisement
The following procedures should only be carried out by trained
personnel
ELECTRICAL CONNECTION
After mounting the ROOF system and fitting the lamp unit to the vehicle,
connect the electrical feed cables. These can be found protruding from the
electrical box, which is situated under the main cover.
Please refer to the remote control instructions at page 16, for guidance on
mast functions.
A) 12/24V Feed
C) Accessories (see page 22)
12
B) 220V ac feed for high voltage
floodlights
D) 12/24Vdc feed for low Voltage
electronic circuits and floodlights
USE AND MAINTENANCE FOR
The following procedures should only be carried out by trained
personnel
PNEUMATIC CONNECTION
(For versions without compressor)
The ROOF telescopic masts require compressed air to extend the mast.
The ROOF systems can be supplied either with a built-in compressor or with a
connection to an external pneumatic source.
All system functions are controlled by the electronic circuit board
ROOF MASTS
PNEUMATIC CIRCUIT
CONNECTION
13
Advertisement
