Advertisement
Quick Links
®
Ezy-Drink
Lead Free Remote Bottle Filler
PRODUCT CODES:
-
85326X
SPECIFICATIONS
−
Lead Free stainless steel construction
IMPORTANT: All Ezy-Drink
premises in good working order.
Inlet
Outlet
Headwork
Working Pressure Range (kPa)
Working Temperature Range (°C)
Nominal Flow Rate (LPM)
TOOLS REQUIRED
−
Power drill
−
Wrench
−
2mm Hex Key (provided)
−
Screwdriver
PRE-INSTALLATION -
−
If the mounting holes do not already exist, mark out and drill the holes in the bench/trough, as shown in the
rough-in dimensions.
Note: Before installation, all lines must be flushed. We recommend that a line strainer be installed prior to drinking
taps to eliminate any foreign material.
228
268
37
®
remote Bottle Fillers are tested in accordance with AS/NZS 3718 and leave our
Min
Max
Min
Max
MOUNTING DETAILS
90
LOCKING
SCREW
SEALING
O RING
G 1/2"
34
1/2" BSP - Female
Stainless Steel Gooseneck
N/A
30
1000
2
65
N/A
Rough-In Dimensions
Version 3, 31 May 2019, Page 1 of 4
Advertisement
Related Manuals for Galvin Engineering Ezy-Drink 85326X
Summary of Contents for Galvin Engineering Ezy-Drink 85326X
- Page 1 Version 3, 31 May 2019, Page 1 of 4 ® Ezy-Drink Lead Free Remote Bottle Filler PRODUCT CODES: 85326X SPECIFICATIONS − Lead Free stainless steel construction ® IMPORTANT: All Ezy-Drink remote Bottle Fillers are tested in accordance with AS/NZS 3718 and leave our premises in good working order.
- Page 2 Version 3, 31 May 2019, Page 2 of 4 INSTALLATION IMPORTANT: Galvin Engineering products must be installed in accordance with these installation instructions and in accordance with AS/NZS 3500, the PCA and your local regulatory requirements. Water and/or electrical supply conditions must also comply to the applicable national and/or state standards. Failing to comply with these provisions shall void the product warranty and may affect the performance of the product.
- Page 3 Version 3, 31 May 2019, Page 3 of 4 4. Fit Bottle Filler − Fit bottle filler into stem ensuring it is seated correctly. − Turn the bottle filler to the desired position. − Once positioned, fit and tighten grub screw. The bottle filler should no longer turn. 5.
- Page 4 WARRANTY The warranty set forth herein is given expressly and is the only warranty given by the Galvin Engineering Pty Ltd. With respect to the product, Galvin Engineering Pty Ltd makes no other warranties, express or implied.