Table of Contents
Advertisement
Cleaning the metal mesh grease filters
Notes
Do not use aggressive, acidic or alkaline cleaning
■
products.
The metal grease filter can be cleaned in the
■
dishwasher or by hand.
By hand:
You can use a special degreaser to remove
Note:
stubborn dirt (article no. 00311297). This can be
ordered through our online shop.
Soak the metal grease filter in hot soapy water.
■
Clean the metal grease filter with a brush and then
■
rinse it thoroughly.
Leave the metal grease filter to drain.
■
In the dishwasher:
Do not clean the metal grease filter together with
■
cookware if heavily soiled.
Place the metal grease filter in the dishwasher,
■
leaving plenty of space around it. Do not trap the
metal grease filter.
For best results, place the metal grease filter in the
■
dishwasher filter side down.
Fitting and cleaning other appliance components
Also clean the inside of the hob extractor system
regularly. You can use a special degreaser to remove
stubborn dirt (article no. 00311297).
Remove the filter cover and clean it with a damp
1.
cloth.
Remove the metal grease filter and container.
2.
Press down on the two catches on either side of the
3.
container to separate the metal grease filter from the
container.
Empty the container if necessary.
4.
Clean the metal grease filter and the container in the
5.
dishwasher.
If required, take off the housing cover underneath
6.
the appliance and clean it.
Clean the parts and dry them before refitting them.
7.
Inserting the metal grease filters
Insert the container.
1.
Insert the metal grease filter.
2.
Ensure that the metal grease filter has been
Note:
inserted correctly. Otherwise, the ventilation system
does not work.
Put the filter cover on.
3.
Resetting the saturation displays
Once you have cleaned or replaced the relevant filters,
reset the saturation indicator so that the
indicators go out.
"‚‚
After the appliance has been switched off,
lights up.
Touch the
symbol.
I
1.
A signal tone will sound. The metal grease filter
saturation indicator has now been reset.
If
is lit, touch the
"‚‚
2.
A signal tone will sound. The activated charcoal filter
saturation indicator has now been reset.
Cleaning
"‚ ‹
and
or
"‚‹
symbol again.
I
en
"‚‚
27
Advertisement
Table of Contents
