Table of Contents
Advertisement
10
PREPARATION
Installation and Configuration
This chapter explains how to install and configure AC Smart IV.
Installation
To use AC Smart IV, build an environment for which AC Smart IV can communicate with devices like
the indoor unit, ERV, DI/DO, DOKIT, AWHP, AHU and I/O Module. Use AC Smart IV to register those
devices.
AC Smart IV should be installed in the following order:
STEP 1. Check the installation environment and configure the device
Check the network configuration against the interfaced devices before installing
AC Smart IV and allocate a unique central control address for each connected
device.
STEP 2. Connect V-Net devices with AC Smart IV.
Use an RS485 cable to connect V-Net devices with AC Smart IV.
STEP 3. Login and register the devices.
Login to AC Smart IV and register those devices that have their address set.
CAUTION
The installation of AC Smart IV must be done by a professional. Be sure to contact a qualified
engineer for the installation. If you have a question or request regarding the installation, contact
an installation professional at an authorized LG service center or LG Electronics.
address.
Advertisement
Table of Contents
