Advertisement
Huawei OptiXstar S890H
Quick Start
Step 2 Remove the dustproof cap from the optical port on the S890H, connect the pre-
deployed photoelectric composite cable to the optical port on the S890H, and
connect a network cable to the XGE port on the S890H.
● Photoelectric composite cables must be routed through metal pipes or buried in
● During the construction, strictly follow the construction requirements of the
● If the optical port of the device is exposed to the air for a long time, the
Step 3 Route the connected S890H through the cable hole, place it in the ceiling, and
push it inwards away from the position directly above the AP along the cable
route until it is at least 10 cm away from the AP edge and side wall.
Issue 02 (2022-12-01)
NO TE
● The preceding figure is for reference only.
● For details about how to install an indoor AP, scan the QR code on the nameplate of the
AP to obtain the installation documentation.
● Indoor APs are usually installed in a ceiling or against a wall by using sheet metal
mounting brackets. The following describes how to install the S890H on the ceiling.
● If an AP is installed against a wall, you route a cable and place the S890H in the ceiling
to avoid hanging the device.
CA UTION
a wall.
photoelectric composite cable.
product performance deteriorates. Therefore, connect a fiber within 20 minutes
after removing the dustproof cap.
Copyright © Huawei Technologies Co., Ltd.
2 Installing the Device
5
Advertisement
