Panel Mounting - JUMO variTRON 500 touch Installation Instructions Manual

2 Mounting
2.3

Panel mounting

Number of mounting elements required
Type (variant)
705004/0 (7'', plastic front)
705004/1 (7'', stainless steel front)
705004/2 (10.1'', plastic front)
705004/3 (10.1'', stainless steel front)
CAUTION!
The front of the device and housing have different protection types!
The protection type on the front side is only guaranteed if the seal is flush and even.
 The mounting elements provided must all be used and must be distributed evenly as shown in the
figure.
Install the device into the panel
1
Step
1
2
22
Action
Insert the device into the panel cut-out from the front until the seal is flush against the pan-
el.
Insert the fastening elements into the recesses of the housing (the number depends on
the device) and use a screwdriver to evenly clamp them against the rear side of the panel
(tightening torque 0.4 Nm).
Number
6 (8 pieces are included in the scope of delivery)
8
8
16
2