Operation; Using The Appliance - LG RC8084 V W Series Owner's Manual

OPERATION

Using the Appliance

Before the first cycle, set the appliance to dry
for five minutes to warm up the drum. Open
the door between loads the first few times you
use the appliance to allow any odours from the
interior of the appliance to disperse.
1
Ensure the lint filter and water container are
clean.
• The lint filter is inside the door rim. It needs
to be cleaned before each drying cycle.
• Open the door and ensure the lint filter is
clean. If it is not, please clean the lint filter.
• Also check if the water container needs to
be emptied for optimum drying results.
WARNING
• Do not drink the condensed water.
NOTE
• In some instances, the appliance may stop
and display an error message indicating
that the condensed water tank is full.
Empty the water tank before restarting the
appliance.
2
Place laundry into the drum after sorting.
• The clothes should be sorted by fabric type
and dryness level and all the strings and
belts of clothes should be well tied and fixed
before being put into the drum. Push the
laundry to the back to keep it away from
the door seal. Otherwise, the door seal and
clothes may be damaged. Close the door.
CAUTION
• Be careful not to trap laundry between the
door and rubber seal.
3
Turn the power on.
• Press the Power button. The indicator icon
above the button will become illuminated,
indicating that the appliance is all set to run.
4
Select the drying programme you want.
• You can choose a programme by turning
the programme selector knob until the
required programme is indicated.
• If you press the Start/Pause button without
choosing a programme, the appliance
will proceed with the Cotton programme.
Please refer to the programme table for the
detailed information.
5
Press the Start/Pause button.
6
After the cycle has finished, open the door
and remove the laundry.
7
Turn off the appliance.
• Press the Power button.
EN
15