Table of Contents
Advertisement
Clear RTC RAM (2-pin CLRTC)
This header allows you to clear the CMOS RTC RAM
data of the system setup information such as date, time,
and system passwords.
To erase the RTC RAM:
1.
Turn OFF the computer and unplug the power
cord.
2.
Use a metal object such as a screwdriver to short
the two pins.
3.
Plug the power cord and turn ON the computer.
4.
Hold down the <Del> key during the boot process
and enter BIOS setup to re-enter data.
If the steps above do not help, remove the onboard battery and short the two pins again
to clear the CMOS RTC RAM data. After clearing the CMOS, reinstall the battery.
CPU and chassis fan connectors (4-pin CPU_FAN, 4-pin CHA_FAN )
Connect the fan cables to the fan connectors on the motherboard, ensuring that the
black wire of each cable matches the ground pin of the connector.
Do not forget to connect the fan cables to the fan connectors. Insufficient air flow inside
the system may damage the motherboard components. These are not jumpers! Do not
place jumper caps on the fan connectors! The CPU_FAN connector supports a CPU fan
of maximum 1A (12 W) fan power.
Intel
LGA1151 CPU socket
®
Install Intel
designed for 6th Generation Intel
processors
For more details, refer to Central Processing Unit (CPU).
DDR4 SO-DIMM slots
Install 2 GB, 4 GB, 8 GB, and 16 GB non-ECC un-buffered DDR4 SO-DIMMs into
these DIMM sockets.
M.2 SSD 2280 connector
This socket allows you to install an M.2 (NGFF) SSD
SATA power connector (15-pin SATA_PWRCON)
This connector is for the SATA power cable. The power cable plug is designed to
fit this connector in only one orientation. Find the proper orientation and push down
firmly until the connector completely fit. To provide power to your SATA device,
connect the SATA power cable to this connector
Chapter 1: Product introduction
LGA1151 CPU into this surface mount LGA1151 socket, which is
®
Core™ i7 / i5 / i3, Pentium
®
2280
CLRTC
PIN 1
, and Celeron
®
®
module.
1-2
Advertisement
Table of Contents
