Table of Contents
Advertisement
SETTING UP YOUR DW702M SECURITY SYSTEM
GENERAL PRECAUTIONS
• Use only the power supply provided with the system.
• Unplug the power supply when the system is not in use for extended periods.
• Do not place any of the equipment near a radiator, vent, or other place where it might be
exposed to heat, moisture, dust, vibrations, or strong magnetic fields.
• Do not attempt to repair the camera. Contact a qualified technician or the dealer for
service. Any change or modification may damage the equipment and invalidate the warranty.
• When installing the camera, follow manufacturer's advice when using power tools, steps,
ladders, etc. and wear suitable protective equipment (e.g., safety goggles) when drilling
holes. Before drilling holes through a ceiling, check for hidden electricity cables and
water pipes.
INSTALLING THE CAMERA
1. Select the position for the camera and
secure the camera stand.
Mounting screws are supplied.
2. Screw the camera onto the bracket
3. Adjust camera to the proper view angle.
Make sure the lens is upright relative to
your subject. Tighten the thumb bolt.
4. Screw the antenna into place on the rear
of the camera. Adjust the antenna to an
upright position.
SYSTEM SET UP - INSTALLING CAMERA
Page 7
Advertisement
Table of Contents
