Cleaning Instructions; Exhaust Vent; Operation; Fuse - Airstream INTERSTATE 24 2024 Owner's Manual

Interior

Cleaning Instructions

1� Turn fan motor off�
2� Remove screws around perimeter of screen insert
only�
3� Clean screen with soap and water solution, dab dry
with a soft cloth, and reinstall�
CAUTION
This product has been manufactured using prime
UV stabilized Polymers for maximum toughness
and durability. However, the use of non-compatible
chemicals will cause cracking and product failure.
Please refer to the user's manual provided in your
owner's packet for more information.
If your vent fails to operate properly under normal
conditions, please contact the manufacturer� Please
have the touring coach retail sales date and the vent
Serial Number readily available when you call� Refer to
your operating guide for contact information�

Exhaust Vent

Operation

The bath exhaust vent (shown above) removes
moisture from the air when using the shower� To
operate, you first need to open the vent.
To open the vent, push the button on the handle to
disengage the clip and slide the handle upward until
the clip engages� Once open, turn the fan on by
pressing the ON/OFF button�
Turn the fan off before closing the vent�
To close the vent, push the button on the handle to
disengage the clip and pull the handle down until the
clip engages in the lowered position�
CAUTION
Turn off the fan before closing the vent. Damage
to the motor can occur if the fan runs with the vent
closed.
5-20
Cleaning Instructions
To clean the screen, make sure the fan is off� Remove
the four (4) screws� Clean with mild soap and water
only�
CAUTION
Do not operate the fan with the screen removed as
this could result in damage or injury.

Fuse

To change the 5 Amp fuse:
1� Make sure the fan is off�
2� Remove the cap by turning it to the left to gain
access�
3� Replace with a type GMA 5A fast-acting fuse�
4� Replace the cap to secure the fuse in the holder�
CAUTION
Turn off the fan prior to closing the vent. Damage
to the motor can occur if the fan is ran with the
vent closed.

Furnace

The manufacturer of the furnace in your touring coach
has been well known in the motorhome industry for
many years� The furnace burns LP gas, and is powered
by 12-volt current from the batteries or power converter
when plugged in to city power� Operating instructions
are located in your owner's packet� If they should
become misplaced, new literature can be ordered
directly from the manufacturer or your Airstream dealer�
The manufacturer also offers a detailed service guide
for your furnace�
The furnace is controlled by the main Multiplex control
panel located in the front roadside roof locker� The
reset button, depending on model, is located on the
furnace behind the access panel or behind the panel
next to the furnace� Remove the panel to gain access�
Carefully read all the manufacturer's instructions
prior to operating. NEVER store flammable material
next to the furnace or in close proximity to the
furnace exhaust outlet on the side of the touring
NOTE
If warranty service is required, use only a
service location recommended by the furnace
manufacturer or your Airstream dealer.
WARNING
coach.
2024 Interstate 24