Table of Contents
Advertisement
Available languages
Available languages
8
9
10
6
•
Slide bagger handle (13) down through bagger cover
and frame holes.
•
Reinstall clevis pin (11) through hole at bottom of bag-
ger handle (13) and slide retainer spring (12) into hole
at the end of the clevis pin (11) until it locks into place.
13
TO INSTALL BAGGER SUPPORT ASSEMBLY
(See Figs. 8 - 10)
•
Using two carriage bolts (1) and two nuts (2), secure the
left hand mid bracket (3) to the left hand front bracket
(4) as shown. Mid brackets should be on the outside
of the front brackets. Repeat on opposite side.
NOTE: Nominal position (5) is when edges of brackets
are aligned as shown.
1
3
•
Using the two perviously removed screws (6), attach
right-hand bagger latch assembly to the backplate and
tighten firmly.
ASSEMBLY
7
Fig. 6
12
Fig. 7
5
4
2
Fig. 8
3
•
Install bagger latch extension spring (7) as shown.
13
•
Repeat steps for left-hand bagger latch assembly.
11
TO INSTALL BAGGER FULL LEVER/EXTENSION
(See Fig. 11)
Before installation or adjusting, tractor engine must be shut
off and parking brake engaged.
• Remove center discharge chute. (See "To Remove
Center Chute" in section 6 of this manual.)
• Remove bolt (1) from chassis. Place cover (2) in slots
(3) in backplate. While holding cover in place, place
lever (4) through slot and reinstall bolt (1). Adjust as
needed.
1
TO ADJUST BAGGER FULL LEVER/EXTENSION
(See Fig. 11)
Slide bagger full extension (3) to the desired position.
•
For the heaviest/wet grasses, slide bagger full exten-
sion (3) all the way in.
•
For the lightest/driest grasses, pull bagger full exten-
sion (3) all the way out.
8
6
Fig. 9
Fig. 10
1
2
3
Fig. 11
5
4
7
4
Advertisement
Chapters
Table of Contents
