Pioneer SC-68 Service Manual page 61

5
[4] DIGITAL MAIN ASSY
Remove the Bonnet 68 by removing the 18
screws.
-----------------------------------------------------------------
[4-1] DIGITAL MAIN ASSY
(1) Remove the HDMI Cable (ADX7732) by
disconnect the connector, and then connect
the another normal HDMI Cable.
Note: Don't connect the HDMI Cable provided
with the product to prevent damage to the
HDMI connector for the DIGITAL MAIN
ASSY. Instead, use the another normal
HDMI Cable to prevent a load from being
applied to the HDMI connector.
Always connect the HDMI Cable because
the iPod iPhone iPad LED blinks, which
causes a shutdown, if the power is turned
on without the cable connected.
(2) Cut the Binder.
(3) Disconnect the three connectors.
(4) Release the cables from the three PCB
binders.
(5) Remove the 39P FFC (ADD7746) by
disconnect the two connectors.
(6) Remove the screw. (BBZ30P060FCC)
Notes on assembling
∗1: HDMI Cabel (ADX7732) and 5P Housing
ASSY (ADX7786) bind together inside.
∗2: PCB binder tilt in the direction of the blue
arrow.
∗3: Attention to style cables as shown in the
photo.
(7) Remove the D-DAC BRIDGE ASSY.
(8) Remove the D-AUDIO BRIDGE ASSY.
Note on assembling
∗4: Twist the PCB binder around the 5P Housing
ASSY (ADX7786) so that it don't contact the
Bonnet 68.
5
6
1
JA8003
Front
DIGITAL MAIN ASSY
CN601
4
5P Housing ASSY
∗2
4
Front
DIGITAL MAIN ASSY
Screwdriver
DAC HIGH ASSY
Front
SC-68
6
7
HDMI Cable
FRONT HDMI USB ASSY
3
x 2
CONNECT ASSY
JA9605
6
3
HDMI Cable
5
∗2
4
5
∗2
39P FFC
CN7901
DISPLAY BRIDGE ASSY
5P Housing ASSY
∗4
D-AUDIO BRIDGE ASSY
7
D-DAC BRIDGE ASSY
7
8
A
B
C
2
∗1
D
AUDIO ASSY
8
E
F
61
8