Table of Contents
Advertisement
3.10 Wire Harness Connections
These two components work together to provide power to the Wii Remote,
allow the player to connect/disconnect the Nunchuk, and communicate with
the Wii.
When the controller select PCB and controller repeater modules are working,
you can see illuminated LEDs.
Stays steady
3.10 W
H
C
IRE
ARNESS
ONNECTIONS
On the controller
select PCB, the
green LED blinks
(ON for four
seconds, OFF for
four seconds,
approximately).
Turns red when the Nunchuk is activated
S
F
TARLIGHT
UN
Blinks slowly
Check the connections at
the:
• controller select PCB
• back of both controller
repeater modules
As you check the
connections, inspect the
cables for damage.
On the controller
repeater module,
the green LED is
steady.
C
O
M
ENTER
PERATION
ANUAL
31
31
OF
Advertisement
Table of Contents
