Troubleshooting - Bravetti F1060B Owner's Manual

OPERATING INSTRUCTIONS
Cleaning Instructions
To ensure many years of service from
your appliance, clean your deep fryer
after every use.
WARNING:
Always remove the plug
from the electrical wall outlet and from
the appliance before cleaning. Allow the
deep fryer and the oil to cool completely
(approximately 2 hours) before cleaning.
Never immerse the control panel, cord or
plug in water or any other liquid.
• Do not place the control panel, cord
or plug in the dishwasher.
• Clean the control panel with a damp
cloth only.
• The oil reservoir, frying basket, and
lid cover can be washed on the top
rack of a dishwasher. Remove the
permanent filter from the fryer lid first.
• The body of the deep fryer can be
washed in warm soapy water. Do
not put the body of the deep fryer in
the dishwasher.
• To clean the permanent filter, remove
it from the cover and wash it in hot
soapy water. Rinse and dry well
before re-inserting it into the deep fryer
cover. Replace the filter cover.
CAUTION
: Do not clean the permanent
filter in the dishwasher.
The Reset Feature
Your deep fryer is equipped with a reset
feature. If for some reason the deep
fryer stops heating, the reason may be
that the reset switch has tripped.
To reset the deep fryer:
1. Unplug the appliance from the
electrical wall outlet and then from the
fryer socket.
2. Let the appliance and the oil in the oil
reservoir cool completely.
3. After the appliance has cooled
completely, lift the control panel and
using the tip of a ball point pen or
pencil, push the thermostat reset
button that is located on the inside of
the control panel (Fig. 10)
4. Re-assemble the control panel to the
housing of the deep fryer and then
you may resume frying.
Reset
Button
Fig. 10
9

TROUBLESHOOTING

PROBLEM POSSIBLE CAUSE
1. The control assembly is not
installed correctly.
2. The magnetic plug is not
connected to the back of the
The fryer is not
control panel.
operating 3. The plug is not connected to
the electrical wall outlet.
4. The electrical outlet is not
energized.
5. The reset switch has tripped.
1. Too much oil in the oil
Oil is spilling
reservoir.
out of the deep 2. The food basket if overfilled.
3. Oil has been used too often
fryer
and is foaming.
Food is tasting
1. Oil is not hot enough.
soggy or
2. The food basket is overfilled.
greasy
Food not
1. Food pieces too large.
cooked
2. Cooking time too short.
completely 3. Oil temperature too hot.
The cooking oil
1. The oil has been used too
is foaming or
often.
emitting smoke
POSSIBLE SOLUTION
1. Re-attach the control panel assembly
– see page 5.
2. Insert the magnetic plug into the fryer
socket and then into the electrical wall
outlet.
3. Insert the plug into the electrical wall
outlet.
4. Reset circuit breaker or replace fuse.
5. Turn the appliance off and let it cool
completely. Then remove the control
panel and press the thermostat reset
button – see page 9.
1. Turn the deep fryer off. Let the oil cool
completely and remove some of the
excess oil.
2. Remove some of the food from the
basket.
3. Turn the deep fryer off. Let the oil cool
completely and refill the oil reservoir
with new oil.
1. Adjust the temperature control dial to
appropriate temperature for food
being fried.
2. Remove some of the food from the
basket.
1. Cut the food into smaller pieces.
2. Continue frying and check the
process continually.
3. Lower the temperature of the oil to
allow the food to cook completely.
1. Let the oil cool completely and
replace with new oil.
10