JVC KD-ADV6160 Service Manual page 15

Dvd/cd receiver

Hide thumbs Also See for KD-ADV6160:

3.2.6 Removing the front unit

(See Fig.10 to 12)

• Remove the top cover and the mechanism section.

(1) Disconnect the flexible wire from connector

mechanism control board at the bottom of the body. (See

Fig.10.)

(2) Remove the screw G attaching the front unit on the top of

the body. (See Fig.11.)

(3) Move the front unit toward the front to release joint h, and

release two joints i and j on the right side of the chassis

base assembly. Then remove the front unit upward. (See

Figs.11 and 12.)

(4) Remove the two screws H attaching the switch board. (See

Fig.12.)

Reference:

You can remove the switch board only without removing the

front unit.

Caution:

When reassembling, attach the flexible wire extending from

the switch board using the double tape. (See Figs.10 and 12.)

Mechanism control board

Double tape

CN202

Flexible wire

Fig.10

on the

Double tape

Front unit

Fig.11

Switch board

Front unit

Fig.12

(No.MA153)1-15