Table of Contents
Advertisement
6.1 Machine
The machine must be regularly cleaned off deposited
dust. When doing so, you should clean the ventilation
openings on the motor with a vacuum cleaner.
Only use our special grease, order No. 049040 (1 kg
tin) for all greasing points.
Only use our special grease, order no. 049065 (400 g
tin) for gear lubrication.
The chain sets used on the machine should be
regularly deresinated, as clean tools improve the
quality of the cut. Deresination is carried out by
soaking the chain set in petroleum or a commercial
deresination agent for 24 hours.
6.2 Guide rail of the chain set
This guide rail must be maintained regularly. This
includes lubricating the chain deflection wheel and
deburring the rail.
Lubricating the carbide guide rail - see Fig. 8
•
Dismantle chain set (see section 4.2).
•
Clean lubrication hole.
•
Place guide rail onto a flat surface.
•
Press the mouthpiece of the grease gun tightly
into the lubrication hole and press until grease
emerges at the deflection. Use a good, acid-free
bearing grease for this purpose.
•
Refit the chain set (see section 4.2).
Deburring - see Fig. 9
•
Dismantle chain set (see section 4.2).
•
Remove chain from the guide rail.
•
Remove the burr using a flat file as shown in
Fig. 9.
•
Replace the chain and refit the chain set (see
section 4.2).
6.3 Chain wheel
The stress on chain wheel 22 (Fig. 3) is particularly
high. If it exhibits extremely visible grooves at the
individual teeth (approx. 0.5 mm / 1/64 in.) it must be
replaced without fail. MAFELL recommends to have
this work carried out by an authorised customer
service shop.
6.4 General sharpening information
Just as important as quality and care of the machine
are quality and care of the saw chain, guide rail and
chain pinion.
If the care of one of these «partners», which are
acting jointly during sawing, is neglected, the
consequences are frequently:
- Wear or destruction of other partners
- Lacking cutting performance
- Bad surface
- A possible safety risk
Nails or adhering sand will damage
the saw chain. They must be
removed from the cut surface.
Saw chains for:
ZSX Ec (Item No. 006955, 006968, 006971, 006972,
006974)
These chains can only be reground
at MAFELL via your appointed
dealer.
6.5 Transport and storage
Danger!
Risk of injury due to improper
transport or storage
Bystanders can be injured by the
machine due to improper transport
or storage For transport and
storage, place the machine onto
the base plate so that the saw
chain is exposed at the bottom. It is
recommended to use the Mafell
transport cart for transport and
storage (see Chapter 8, "Special
accessories").
Clean the machine thoroughly if the machine is not
used for a longer period of time. Spray blank metal
parts with a rust-proofing agent.
-31-
Advertisement
Table of Contents
