Table of Contents
Advertisement
2 .0
2.1 OPERATING VAC-U-PULL
All the following operations must only be carried out by trained and qualified personnel.
Failure to comply with the instructions below or tampering with the pneumatic connections, exempts the
manufacturer from any liability for non-compliance or damage caused by malfunctioning of the equipment .
The following are the steps for the proper use of the VAC-U-PULL equipment:
1 .
Clean the area you intend to place the VAC-U-PULL .
2 .
Tilt back the unit onto its rear wheels until the foam base is off the ground then roll it to your
intended work area and position it so it is pointing at the area of repair, as straight as
possible .
3 .
Connect compressed air and press down on the base with your foot and the base should
stick to the ground .
4 .
Adjust the height so that it is level with what the VAC-U-PULL will be pulling .
5 .
Attach the VAC-U-PULL hook or multi-hook attachment to the pulling point .
6 .
The pull force required will depend on the repair to be carried out with the limitation of
550 lbs . A higher pulling force could damage the mechanism or cause the base to lose its
vacuum, resulting in the possible overturning of the base .
WARNING! Always use this system for pulling forces of less than 500 lbs .
2.2 PRECAUTIONS
All the following operations must be carried out only by trained and qualified personnel. Failure to comply
with the provisions below or tampering with the pneumatic connections, exempts the manufacturer from any
liability for non-compliance or damage caused by malfunctioning of the equipment .
The following instructions must be observed by the operator .
The base does not empty sufficiently due to poor sealing of the base or rubber, excessive force, or failure of
the compressed air supply or ejector . In such a situation, the VAC-U-PULL will lose its hold and may fall in the
direction of the force being exerted .
WARNING! When pulling the chain, no persons or materials should be placed around the equipment.
For Instructional Videos:
https://www.youtube.com/c/Prospotwelding
INSTRUCTIONS
All Info Copyright © Pro Spot International Inc. 2023
4
Advertisement
Table of Contents
