Introduction; About Vac-U-Pull - Pro Spot VAC-U-PULL Instruction Manual

1 .0

1.1 ABOUT VAC-U-PULL

Thank you for choosing Pro Spot's VAC-U-PULL . The VAC-U-PULL provides an excellent solution for dent repair on
vehicles consisting of a portable pulling system that is fixed to the ground by means of a vacuum system. The 500 lbs
pulling force, controlled by a winch system, provides the necessary force for each repair .
The correct operation of this equipment is subject to the correct connection of the different parts that make it up.
These operations must be carried out by trained and experienced personnel .
The manufacturer is not responsible for the safety of the equipment if the instructions for use, maintenance and repair
in this manual are not followed, or if the equipment is used for other purposes .
The VAC-U-PULL system is simple to learn, easy to use, safe and very efficient.
WARNING! For your safety, read this manual carefully .
Be very careful, as incorrect handling can cause serious damage to materials and people . The necessary
precautions for use and safety are listed below:
• Standing behind or in front of the equipment when it is under tension can cause serious injury . Always
stand off to the side.
• Ensure the floor area is clean (dust, liquids or other elements) and without cracks to guarantee the
correct sealing of the foam .
• When moving the VAC-U-PULL, tilt it back onto the rear wheels until the foam is off the ground to prevent
damaging the foam seal .
• The equipment requires compressed air supply for its operation (recommended operating pressure 60 psi).
Check that the base is fixed.
WARNING! Always use it with connected compressed air .
Always check the air connection before unscrewing the sheet metal, otherwise, the floor fastening will
not be secured .
If the equipment will operate without compressed air, Pro Spot is not responsible for any damage to
persons, materials or other items in the vicinity .
3

INTRODUCTION

All Info Copyright © Pro Spot International Inc. 2023