Logitech 3D MOUSE & HEAD TRACKER Technical Reference Manual page 59

Where in Table 6-6 (continued),
XMT6...XMT0 = Transmitter Type Connected
LRR15...LRR0 = Distance from receiver's lower left microphone to
LTR15...LTR0 = Distance from receiver's lower microphone to top
BD0 = Button Disabled Status
LRX15...LRX0 = Distance from transmitter's lower speaker to lower
LTX15...LTX0 = Distance from transmitter's lower left speaker to
LCX15...LCX0 = Distance from transmitter's lower left speaker to
RES = Reserved for future extensions [0]
Set Slave Transmitter Type
This command sets the Slave control unit's transmitter type. The
command structure is in a hex, 5-byte format as follows:
Byte 1 2A
Byte 2 24
Byte 3 02
Byte 4 01
Byte 5 Slave's transmitter type
The transmitter-type byte is generally derived from sending the *m
(Current Operating Information) command to the Master control unit,
and getting the Master control unit's transmitter type. The Master control
unit's transmitter type is also the Slave control unit's transmitter type.
Application Programming Interface
Value = 15 (No Transmitter Connected)
Value = 14 (Mouse Transmitter Frame)
Value = 13 (Head Tracker Transmitter Frame)
Value = 12 through 0 (Reserved)
lower right microphone (.001 inch units)
microphone (.001 inch units)
Value = 1 (Buttons Disabled on Receiver)
Value = 0 (Buttons Enabled on Receiver)
right speaker (.001 inch units)
top speaker (.001 inch units)
calibration microphone (.001 inch units)
47