Logitech 3D MOUSE & HEAD TRACKER Technical Reference Manual page 18

Chapter 2
6
3. Plug the receiver cable into the Receiver connector on the rear panel
of the control unit (see A in Figure 2-1). The arrow on the cable
should appear on top (see Figure 2-2).
Figure 2-2. Positioning the Cable Arrow
4. Plug the transmitter cable into the Transmitter connector (see B in
Figure 2-1).
5. (Optional) plug the audio cable into the Audio Out connector (see C
in Figure 2-1).
6. Plug the rounded end of the computer cable into the Serial Port
connector (see D in Figure 2-1).
7. Connect the computer cable's 9-pin plug into an available serial
(COM) port in the back of your host computer. If your computer has
a 25-pin serial port connector, attach the 9- to 25-pin adapter
provided. Remember which serial port you use, because you will have
to indicate it when you run the TEST3D program.
8. Plug the rounded end of the power supply cable into the Power Supply
connector (see E in Figure 2-1).
9. Plug the power supply into an AC outlet or power strip.
10. Turn on your host computer.
11. Turn on the control unit. Flip the On/Off switch to the ON position.
The red Power LED on the front panel of the control unit should
light.