Advertisement
Available languages
Available languages
9
The side at which the door opens can
be changed, from the left side (as
supplied) to the right side, if the
installation site requires.
Warning! When reversing the door, the
appliance must not be connected to the
mains. Ensure that the plug is removed
from the mains socket.
Tools you will need:
8mm socket wrench
Cross-shaped screwdriver
Thin-blade screwdriver
N o te : Before you start lay the
refrigerator on its back in order to
gain access to the base, you should
rest it on soft foam packaging or
similar material to avoid damaging
the backboard of the refrigerator. To
reverse the door, the following steps
are generally recommended.
1. Stand the refrigerator upright.
EN
2. Open part ① on top of the freezer
door as the figure Ⅰ shows ,and then
disconnect electrical connector ② as
the figure Ⅱ and Ⅲ show .
Ⅰ
Ⅱ
Ⅲ
8mm wrench
3. Keep the door open, then take down
part ① and part ② on the refrigerator
body. Take down part ③ , then
out the wire ④ from the wire chase
of part ⑤.
③
④
① Upper hinge cover
Left upper hinge cover
③
⑤ U
①
① Cover plate
② Display board connecting
wire
⑤
② Top cover block
Display board connecting wire
④
pper hinge part
②
take
①
②
Advertisement
