Specifications; Important Safety Information - KNOVA KN 6050 User Manual

SPECIFICATIONS

Pad diameter
Spindle
Orbital stroke
Air pressure
Air consumption
Specifications are subject to change without notice

IMPORTANT SAFETY INFORMATION

WARNING! Read, understand and
follow all instructions and warnings
before operating this tool. Failure
to do so may result in personal injury and/or
property damage and will void warranty
1. Use only paper sanding disks with
the proper adhesive. Read, understand
and follow all adhesive manufacturers'
directions. DO NOT USE CLOTH
BACKED SANDING DISKS WITH THIS
TOOL.
2. Make sure sanding pad RPM rating
matches Free Speed rating of this tool.
3. Wear a dust mask while operating this
tool. Read, follow and understand
manufacturers instructions on paint,
primer, paint preps, glazing, body filler,
etc. for additional respirator and
ventilating requirements.
4. Always use approved eye and ear
protection when using air powered
tools. If raising dust/debris, wear a
suitable mask. Do not wear loose
clothing or jewelry.
5. Always operate tool a safe distance from
yourself and others in the work area.
Keep footing and balance at all times.
6" (152.4 mm)
5/16" - 24 UNF
5/16" (7.93 mm)
90 PSI
4 CFM
Free speed
Air inlet
Recommended hose size 3/8" ID
Length
Weight
6. Make sure work piece is secure to allow
safe operation of the tool with both
hands. Do not hold the work piece in
your hand, lap or against any part of
your body.
7. Make sure trigger is in the "off" position
before connecting or disconnecting
the tool from air source. Disconnect tool
from air source before changing
accessories, performing service and
when not in use.
8. Follow air source manufacturer's
directions for connection of regulators,
filters and other accessories to air
source. Do not install quick couplers
directly at tool air inlet. This causes inlet
failure due to excess weight and vibration.
Use a whip hose between tool and quick
couplers.
9. DO NOT OVERLOAD! Do not force tool.
Match tool capacity to work load
requirement. Use tool within its rated
capacity and only for its designated
purpose. Overloading air tools will cause
premature wear and/or permanent
damage of internal and external drive
parts and will void warranty.
10. Inspect hoses and fittings for wear and
damage prior to using tool. Do not
carry or drag tool by the air hose. Keep
air hose free from obstruction, twisting
and binding.
10,000 RPM
1/4" (6.3 mm)
8-3/4" (222.3 mm)
4.4 lbs. (2 kgs.)