Connection Diagram - Magnum H64 Installation Instructions & User Manual

Wiring diagram

5. Connection diagram

Thermostat connection W1-W8: Connection thermostats (Master thermostat always on W1).
Wiring control centre H64-CC
Precautions
Actuator Connection (230VA) R1-R8: R1 = W1, R2 = W2 etc....
①W1-W8: Connected to the thermostat, low voltage, regardless of null line and fire line,
Group R1-R4: Are dual and 8 actuators (4 per input) can be connected there.
W1 must be connected to the master thermostat, W1 corresponds to an area.
Group R5- R8: Max 4 actuators per input.
② R1-R8: Connected electric heating actuator, R1 corresponds to W1, R2 corresponds to W2, and so on,
Total: R1-R4 (4x8) and R5-R8 (4x4) = 48 actuators.
R1-R4 can be connected to two electric heating actuators respectively, the total current does not exceed 5A.
CAUTION: The total current should never exceed 5 amps.
Pump
Power R1
AC
L N N L L N L N L N L N L N L N L N L N L N L N L N L N
Circulation pump current<5A
Water pump(Current<5A)
Power supply (100-240VAC 10A)
Power supply(100-240VAC 10A)
L:Fire Line N:Null line
L = Line N = Neutral
Assembly and installation H64-CC Control unit
R2 R3 R4
R1-R8: Aansluiting actuatoren (230VA)
R1-R8:Connected electric heating actuator
(Totale stroom <5A)
(the total current<5A)
:Earth line
= Earth
R5 R6 R7 R8 G1 G2
COM NOCOM NO
G1, G2: Passive connection (potencial-free contact)
G1、G2:Passive linkage
Connection for boiler, heat pump or mixing system (Max. 5Amp.)
(can be linked to boiler, heat pump host, mixed water device)
(Current<5A)
35
W1 W2 W3 W4 W5 W6
° C ° C ° C ° C ° C ° C
W1-W8: connect to the low voltage
W1-W8:connect to thermostat
thermostat, without polarity.
low
voltage, regardless of null

W1 must be connected to the master
line
and
fire line. W1 must
thermostat.
connect with master thermostat
Port switching to cooling mode
Cooling changeover port
W7 W8 Cooling
° C ° C COM NO