Martec SATURN Series Installation Manual

We strongly recommend that you read this manual carefully before installation.
Installation MUST carry out by a qualified and licensed electrician.
Models Parameters:-
MXFSS25W 28W Exhaust Fan Square White
Technical Specification
Air Extraction m³/hr
Power Wattage
Voltage
Capacity (L/S)
Materials / Housing
IP Rating
Cutout Size
Noise Level (dB)
Minimum Height
Ducting Size
Accessories Included
Installation Location
NB: This product is for indoor installation only.
• Unit must be installed into a horizontal location, not suitable for wall
mount or raked ceilings
• Check ceiling cavity for hidden beams, structures and concealed
electircal cabling prior to installation
• Unit should not be installed directly above shower or bath cubicles
or in any location where splashed water can contact the unit, or the
switch can be reached and turned on by someone within a bath or
shower
• Position fan in a central location to maximise ventilation to all areas
• Ensure air is ventilated to an outside location (not into roof cavities)
via the use of a duct/grill assembly which is not supplied
• Do not install the exhaust fan within 1m distance from a ceiling or wall
mounted heat source
E: sales@martecltd.com.au | P: 02 8778 7500
www.martecaustralia.com.au
S A T U R N S e r i e s I n s t a l l a t i o n G u i d e
320m³/hr
28W
220-240V 50Hz
≤89L/S
Plastics with ABS Fascia
IPX4
Dia 295mm
<45dB
220mm clearance height above the unit
150mm
900mm cable with 3 pin plug
CAPACITY DISCLAIMER
All capacity figures and technical data quoted is
provided by the manufacturer, Capacity figures
are based on the unit free flowing (not connected
to ducting). If you are ducting this unit it is advis-
able to keep the duct run as short, straight and
tight as possible.
Wiring Diagram