Tools, Consumables, And Expendables; General; Tooling; Consumables - Hartzell HC-D2MV20-3 Owner's Manual And Logbook

HARTZELL PROPELLER OWNER'S MANUAL

1. Tools, Consumables, and Expendables

CAUTION:
A. General
(1) The following tools, consumables, and expendables will
be required for propeller removal or installation:
NOTE:
B. Tooling
20 Spline
• Safety wire pliers (Alternate: Safety cable tool)
• Torque wrench
• Torque wrench adapter (Hartzell Propeller Inc.
P/N BST-2910)
C. Consumables
• Quick Dry Stoddard Solvent or Methyl-Ethyl-Keytone (MEK)
D. Expendables
• 0.032 inch (0.813 mm) Stainless Steel Aircraft Safety Wire
(Alternate: 0.032 inch [0.81 mm] aircraft safety cable, and
associated hardware)
• O-ring, cylinder-to-stud seal - Refer to Table 3-1.
INSTALLATION AND REMOVAL
140
INSTRUCTIONS AND PROCEDURES
IN THIS CHAPTER MAY INVOLVE
CRITICAL PARTS. REFER TO THE
INTRODUCTION CHAPTER OF THIS
MANUAL FOR INFORMATION ABOUT
PROPELLER CRITICAL PARTS. CONTACT
HARTZELL PROPELLER INC. FOR
THE IDENTIFICATION OF SPECIFIC
PROPELLER CRITICAL PARTS.
The steel hub reciprocating propellers covered
in this manual are manufactured to install on
an SAE Number 20 Spline engine shaft. The
spline type is indicated in the propeller model
identification number stamped on the hub. For
example, HC-D3MV20-6L indicates an SAE 20
spline.
61-00-40
Page 3-3
Rev. 5 Apr/23