Table of Contents
Advertisement
146 Roof rack and hitch ›
NOTICE
Risk of damage to the key!
Place the tow bar in the standby position, with the
▶
key upwards, and store in the box.
Coupling or uncoupling a trailer or accessory
The following information describes the procedure
for coupling and uncoupling a trailer. The information
also refers to another accessory, e.g. a bike carrier.
WARNING
Risk of an accident!
Do not use the safety eye for towing.
▶
Distribute and fix the load correctly.
▶
The trailer has a 13-pin electrical socket. If the
trailer has a 7-pin connector, use a corresponding
adapter from the ŠKODA Original Accessories.
Coupling
›
Install the tow bar.
tear-off rope must sag against the vehicle in all
trailer positions.
Uncoupling
Uncoupling takes place in reverse order.
Power supply of the trailer power network
In the electrical connection between the vehicle and
trailer, the trailer is powered by the vehicle.
NOTICE
Risk of damage to the vehicle electronics!
The total power consumption of all consumers con-
nected to the trailer power supply must not exceed
350 watts.
Removable tow coupling
›
Insert the cover cap
for the mounting re-
cess.
›
Swivel out the electri-
cal outlet
.
A
›
Put the trailer drawbar
onto the ball head.
›
Plug the electrical trail-
er plug into the socket
.
A
›
Hook the tear-off rope
of the trailer onto the
safety eye
. The
B
Troubleshooting
When inserting the tow bar - the operating lever
did not turn or the release pin did not come out
›
Turn the control lever all the way down.
›
Remove the tow bar from the mounting recess.
›
Clean the tow bar and mounting recess contact
surfaces.
When removing the tow bar - the tow bar did not
fall freely into your hand after detachment
›
Press on the tow bar with your other hand from
top to bottom.
Technical data
Tow hitch attachment points
Distance of the attachment points
A
Length of the rear overhang to the centre of the
B
ball head
Distance of the front attachment point to the
C
centre of the ball head
Distance of the rear attachment point to the
D
centre of the ball head
Distance of the rear bumper to the centre of the
E
ball head (according to the ECE-55 standard)
Distance from the centre of the ball head to the
F
road (according to the standard ECE-55)
Fastening points on the body
G
Advertisement
Table of Contents
