Advertisement
2.
Gently lift up the top cover as shown on Figure 2.
3.
Place your 2.5" SATA hard disk into the Enclosure and then push the hard disk into
Enclosure SATA interface connector.
4.
Slightly align the top cover from the end of Enclosure to make sure it aligns with
the middle plastic frame, then push down from front side on top cover to close the case.
5.
After finish all hardware installation, you can connect the USB cable from the
Enclosure to the computer system.
2.5" USB SATA HDD External Enclosure
Figure 2
Figure 3
Figure 4
Page | 5
Advertisement
