Related Manuals for X-media XM-EN3200-BK
Summary of Contents for X-media XM-EN3200-BK
- Page 1 User Guide 3.5” USB HDD External Enclosure Model No.: XM-EN3200-BK XM-EN3400-BK For the most up-to-date information, please visit www.x-mediausa.com Version 1.1...
- Page 2 3.5” USB2.0 HDD External Enclosure Contents Package Contents ......................3 Chapter 1 Product Overview …….………………….….……………………….………………………… 3 1.1 Introduction ……………………….…………………………………….………………….. 3 1.2 Features …….………………….….…..……………………………………………………… 3 1.3 System Requirement ………………...……………………………….…………………. 4 Chapter 2 Installation Guide ………………..…………………………………………..………………….. 4 2.1 Hardware Installation …………….………..……….……………………..………….. 4 2.2 Driver Installation ………….………………..…………………….…………..…………...
-
Page 3: Package Contents
Conventions The “Enclosure” mentioned in this User Guide stands for following products: XM-EN3200-BK or XM- EN3400-BK without any explanations. All these devices are sharing this User Guide. All product models listed just differ in appearance and figure in this User Guide. -
Page 4: Chapter 2 Installation Guide
3.5” USB2.0 HDD External Enclosure Plug and Play & Hot Swappable LED indicator 1.3 System Requirement 3.5” IDE or SATA compatible storage device USB enabled computer system with available USB port Microsoft® Windows® 2000/XP/Vista/7/8/8.1/10 (32/64-bit); MAC 9.x or above Chapter 2 Installation Guide WARNING:... - Page 5 3. To install IDE hard disk on Model XM-EN3400-BK, connect the IDE and Power cable as shown in Figure 3. Figure 3 To install SATA Hard disk on Model XM-EN3200-Bk (Shown in Figure 4) or XM- EN3400-BK (Shown in Figure 4.1) Figure 4 Figure 4.1...
-
Page 6: Driver Installation
3.5” USB2.0 HDD External Enclosure 2.2 Driver Installation No driver installation is required for USB enabled computer systems, as this enclosure uses natively installed driver. Supported operating systems should automatically detect and install the enclosure. 2.3 Verifying Installation To verify the installation: 1. - Page 7 3.5” USB2.0 HDD External Enclosure 2. Locate the Disk that says it is “Unallocated”, then right-click in the section that says “Unallocated” and a new window will pop up, then select “New Partition”. Follow the instructions in the wizard to complete setting up the drive. Once completed, the Disk should show up as “Healthy”...