Assembly And Operation; Charging Warning - GRE RBR75 Instruction Manual

ASSEMBLY
A: Floater
B: Upper cover
B-1: Jet head
C: Cartridge filter
D: Filter
E: Bottom base
F: Charger
There is a rotation jet head at the upper cover, the
water is passing from bottom to the jet head to
make the robot moving. While facing obstacle,
the jet head turns around 180 degrees, the robot
rounds the obstacle and moving by another line.
The rubbish is collected and installed by the bottom
filter cabine.

ASSEMBLY AND OPERATION

Charging warning:

• Only use the external adapter and the charging
cable provided.
• Make sure that the robot and charger ports are
clean and dry before installation.
• Power up the robot before using it for the first
time (about 5 hours)
1. Take the pin cover off before charging.
2. Plug the charger into the charging port, then
start to charge.
Note: Once the robot starts charging, the indicator
light on the external adapter will turn red. When the
robot is fully charged, the indicator light will turn
green.
3. After charging, put the pin cover back on the
charging port. Make sure that the pin cover is
fully sealed before submerging in the water.
INSTRUCTION MANUAL
Bottom cover body assembly
Pin cover
Charging pot
EN
Switch
Charger