Page 1
P r o f e s s i o n a l s REMS Amigo REMS Amigo E REMS Amigo 2 REMS Amigo 2 Compact REMS Amigo 22 V Instruction Manual ..........4 REMS GmbH & Co KG Maschinen- und Werkzeugfabrik Stuttgarter Straße 83...
● Do not use the REMS quick-change die heads S together with extension d) Remove any adjusting key or wrench before turning the power tool on. A (accessory art.
WARNING WARNING 110 V~, 50 – 60 Hz; 1200 W REMS electric die stocks for cutting pipe threads and bolt threads for right and left REMS Amigo 2 230 V~, 50 – 60 Hz; 1700 W hand threads (REMS Amigo E).
See also section 5. Troubles. be completed with a fully charged Li-Ion battery. The LED lights red and the REMS Amigo 22 V switches off if overloaded. After a short dwell time, the LED 1.6. Dimensions lights green again and thread cutting can be continued. The LED fl ashes red L ×...
1. Cut pipe/rod at a right angle and burr-free. If a thread is to be cut on a short length of laid pipe, the REMS quick-change 2. Fix the support bracket (2) about 10 cm from the end of the pipe or rod by die heads S must be used with an additional guide sleeve (19) on the cover putting the support bracket from underneath against the pipe (rod) (Fig.
(REMS Amigo 22 V). ● LED of the machine status check (Fig. 7 (22)) fl ashes red due to ● Wait until the LED lights green. Switch on REMS Amigo 22 V and let it run exceeded motor temperature (REMS Amigo 22 V).