Content General Description Function Warnings Warranty Technical Data Table with technical data Dimensional data Installation Suspension Calculating number of fans required Positioning Electrical Connections 230VacSupply Connection options 4.2.1 Connection without speed controller 4.2.2 Connection with speed controller Setting, Operation and Maintenance Setting the thermostat Operation Maintenance...
It’s a reference to operation and installation savings achieved of the SD-EC destratification fan. For the sake of safety and to guarantee proper function, it is vital that you read 1.3 Warnings...
2.2 Dimensional data Select the SD-EC model based upon air output, throw of the unit and height of the room. Then simply take the ca- lulated air volume and divide by the air volume produced by your selected SD-EC model. The resulting figure is the qty needed for your application.
6, diagram 5. ATTENTION! Attention The SD-EC needs 2 signals in order to run. 4. Electrical connections The thermostat contact on the WCU has to be closed and the speed setting has to be made. If one of these signals is...
Example diagrams 10V (OUT) 10V (OUT 230V AC 6.2 Diagram 2 - SD-EC with internal connections on the 6.1 Diagram 1 - SD-EC without internal connections on 0-10V ( IN ) 0-10V ( IN motor (models SD-EC 5, 7 & 10) agram 1 WCU-EC without internal connections on the motor (WCU 40).
Diagram 6 Several WCUs controlled by 1 speed regulator If more than one SD-EC needs to be connected to one speed controller, please make sure that the 10V supply of the If more than one WCU needs to be connected to one speed regulator, please make sure that the 10V supply of the different units are NOT connected to each other.
Page 8
® Tel: +44(0)1473 830 551 Fax: +44(0)1473 832055 www.spaceray.co.uk info@spaceray.co.uk Gas Fired Products (UK) Ltd Chapel Lane Claydon Ipswich Suffolk, IP6 0JL FACTORIES: IPSWICH, ENGLAND - CHARLOTTE, N.C, U.S.A SD-EC Manual May 2023...