Vibration And Noise Reduction - Kingfisher MCS2200 Instructions Manual

c) Pay attention to national and local regulations. National and
local regulations may restrict the use of this product.
d) Only use replacement guide bars and saw chains specified
by the manufacturer or equivalent replacements. Using non-
approved cutting attachments can result in personal injuries and
damage to property.
e) Before using the product and after any impact or dropping,
check for signs of wear or damage and repair as necessary.
f) Never remove or modify any guard or safety component. Ensure
that guards and other safety components necessary for machine
operation are in position, in good working condition and properly
maintained to avoid injuries.
g) Training of all operation is necessary for first-time and
inexperienced operator.
h) Remove branches in section.
Health surveillance
All employees should be part of an employer's health surveillance
scheme to help identity any vibration related diseases at an early
stage, prevent disease progression and help employees stay in
work.

Vibration and noise reduction

To reduce the impact of noise and vibration emission, limit the time
of operation, use low-vibration and low-noise operating modes as
well as wear personal protective equipment.
Take the following points into account to minimise the vibration and
noise exposure risks:
1. Only use the product as intended by its design and these
instructions.
2. Ensure that the product is in good condition and well maintained.
3. Use correct attachments for the product and ensure they are in
good condition.
4. Keep tight grip on the handles/grip surface.
5. Maintain this product in accordance with these instructions and
keep it well lubricated (where appropriate).
5063022106193_MNL_IN_V04.indd 10 5063022106193_MNL_IN_V04.indd 10
10
03-04-2023 11:25:54 03-04-2023 11:25:54