Advertisement
USING THE SUPPORTS
1.
The supports are used with Sub Adapter (B).
• Stepped level for Support 1 (C) is 0‑8 mm. Figure 4
• Stepped level for Support 2 (D) is 0‑33 mm. Figure 5
2.
Loosely assemble the support (C or D) and an Adjustment
Screw (E).
Figure 4
3.
Place entire assembly onto guide rail. Set and lock
adjustment screws by first putting moderate pressure
on Adapter (A) to ensure it is set square. While pushing
down on Adapter (A), adjust the support to the top of
the work surface and tighten adjustment screws. Test
movement of the assembled router to verify it sets square
and moves smoothly.
4.
Move router to desired position.
Figure 6
CAUTION
Make sure the cut line of the bit does not contact the guide rail.
Figure 5
ADJUSTING THE SET SCREWS
1.
Remove the Guide Rail Adapter from the guide rail and turn
the two set screws shown in (Figure 7). Do not over tighten.
2.
Place back on the guide rail and verify that it moves freely
with no slack.
Figure 7
NOTE: Even pressure must be applied when adjusting and
tightening set screws, if the adapter is not square it may cause
chatter during operation.
KNOWN COMPATIBLE ROUTERS
RP0910
RP1110C
3612
3612C
3612BR
RP1800
RP1801
Makita*
RP1800F
RP1801F
RP2300FC
RP2301FC
RP0900K
Compact Routers
using Plunge Base
196094-2
DW621
D
WALT*
E
DWP611PK
R1631K
Ryobi*
R163G
* D
WALT is a trademark of The Stanley Black & Decker Corporation—Makita is
E
a trademark of Makita Corporation—Ryobi is a trademark of Ryobi Limited and is
used by Techtronic Industries Company LTD
NOTE: Routers listed are compatible with the POWERTEC
71085 Guide Rail Adapter.
If you do not have any of the listed routers, check the through-
mounting hole measurement on your router base and compare
to the base measurements in (Figure 1) to verify if either set will
work for you.
F
8 mm rod
F
8 mm rod
G 12 mm rod
G 12 mm rod
G 12 mm rod
G 12 mm rod
G 12 mm rod
G 12 mm rod
G 12 mm rod
G 12 mm rod
G 12 mm rod
F
8 mm rod
F
8 mm rod
F
8 mm rod
F
8 mm rod
F
8 mm rod
F
8 mm rod
Advertisement
