Advertisement
PACKAGING CONTENTS
ITEM DESCRIPTION
A
Guide Rail Adapter
B
Sub Adapter
C
Support 1, 0‑8 mm
D
Support 2, 0‑33 mm
E
Adjustment screws
F
Rod 8, 8 mm diameter x 250 mm
G
Rod 12, 12 mm diameter x 250 mm
Figure 1
NOTE: The guide rail adapter uses two sets of mounting rods.
One set is 8 mm and 3.31" on center.
The other set is 12 mm and 4.54" on center.
ASSEMBLY
CAUTION
Always be sure router is switched off and unplugged before
installing or removing from guide rail.
1.
Loosely assemble Guide Rail Adapter (A), with two
adjustment screws (E). Place onto guide rail channel (not
included). Slide back and forth to verify that the adapter
moves freely.
Figure 2
QTY
1
1
1
1
5
2
2.
Tighten Set Screws (See Adjusting Set Screws Figure 7) to
2
remove all slack from adapter. Verify free movement again.
Remove adapter from rail.
3.
Insert rods through appropriate router base guide‑holes
then into adapter (A). Using sub adapter (B) with adjustment
screws (E) loosely inserted, slide sub adapter (B), with the
support notch positioned to the outside, onto rods leaving
all 4 adjustment screws loose. Make sure rods are inserted
all the way into the holes on the guide rail adapter, then
tighten adjustment screws.
Figure 3
Advertisement
