Marathon Berlin User Manual page 20

Manual time setting
To enter the Clock/Calendar setting mode, press and
•
hold the button for 3 seconds until the
MODE/SET
digits flash.
Press + or - button to adjust the desired value and
•
press the button to confirm and move on to next
MODE
setting.
Hold down the + or - button to speed up setting
•
Press the button to confirm settings and exit
•
MODE
from time setting mode. The time setting mode will
automatically exit after 15 seconds if no button is
pressed.
The setting sequence is shown as follow
1 Press = 12/24 Hour
2 Presses = Time Zone
3 Presses = Hour
4 Presses = Minute
5 Presses = Second
6 Presses = Language
7 Presses = Year
8 Presses = Month
9 Presses = Day
The days of the week can be displayed in 8 different
•
languages: German (GE), French (FR), Spanish (ES),
Italian (IT), Dutch (NE), Danish (DA), Russian (RU), and
English (EN).
The language and their select abbreviations for each
•
day of the week are shown in a table at the back of
this manual.
NOTE:
The Second setting is adjusted to zero only.
•
Time Zone function: If your area can receive an
•
RC-DCF frequency signal, the time zone function
should be set to 0. The Time Zone function is used
in areas where a DCF frequency signal can be
received but the time zone is different from the
German Time.
Daily alarm function
Press button to select to view: Time /
•
MODE/SET
Time & Day of Week / Alarm Time ( "AL" shown on
the LCD)
When viewing the alarm time, hold the
•
button for 3 seconds to enter the alarm setting
mode. Press + or - button to adjust alarm time.
Press the button to confirm the setting.
MODE
Press button to activate or deactivate the
•
AL ON/OFF
alarm function. If the alarm is activated, the
will appear on the screen.
Press the button to silence the alarm and
•
SNOOZE
enter snooze mode, the alarm will sound again in 5
minutes.During snooze mode the
on the LCD.
Press any button other than the
•
to stop the alarm. The alarm sound will continue
for 2 minutes before stopping.
NOTE: The snooze function can be repeated up to 7
times.
Dimmer
Press the button to adjust the LED brightness
DIMMER
(off-med-high), when powered by the adaptor,
Low battery indication
The low battery icon
outdoor temperature digit indicating the outdoor
sensor battery is low and batteries should be replaced.
Precautions
Use a pin to press the reset button, if unit is not
•
working properly.
Avoid placing the clock near interference or metal
•
frames such as computer and TVs.
The clock will lose the time when the battery is
•
removed.
Do not expose to direct sunlight, heavy heat, cold,
•
high humidity or wet areas
MODE
icon
icon will flash
button,
SNOOZE
will display beside the
EN