Brave BRI4100IER Operating Instructions Manual page 25

Operating Instructions
• Only operate generator outdoors.
• Prevent exhaust gas from entering, through windows doors or ventilation intakes, any confined
areas.
• DO NOT operate generator inside any enclosed or roofed areas. This includes the generator
compartment of any recreational vehicle (RV).
• Keep the generator away from other electric cables or wires such as commercial power supply
lines.
• The DC receptacle (in the Battery Charge section of the control panel) can be used while the AC
power is in use. If you use both at the same time, be sure not to exceed the total power for AC
and DC.
• Most appliance motors require more than their rated wattage for start-up.
• It is normal for the run time indicator to have 1-2 hours on the meter from the factory for testing
and quality assurance inspections.
• This generator uses a system ground which connects the ground terminals in the AC
receptacles on the control panel to the unit frame. The AC neutral wire is not connected to
the system ground. If you check the receptacles on this generator with a receptacle tester, the
ground circuit condition will appear different than it would for a receptacle in your home.
Never start or shutoff the generator with electrical loads connect-
ed and in the operational mode (on switch
activated).
1. Unplug all electrical loads from the generator.
CAUTION
2. Make sure the generator is in a level position.
3. Open the Fuel Valve by turning the Fuel Valve to the "ON"
BRAVE GENERATOR PRODUCT SUPPORT 1-888-980-4938 BRAVE GENERATOR PRODUCT SUPPORT 1-888-980-4938
& Owner's Manual
position.
25 25