Subscribe to Our Youtube Channel
Related Manuals for Truper PIPI-27
Summary of Contents for Truper PIPI-27
- Page 1 Manual Spray Gun 10 PSI - 50 PSI Air Pressure Applies for: Model Code PIPI-27 19510 PIPI-27 Read this manual thoroughly CAUTION before using the tool.
-
Page 2: Table Of Contents
Keep this manual for future references. Start Up The illustrations in this manual are for reference only. They might be different from the real tool. Maintenance Troubleshooting Notes Technical Data PIPI-27 Code 19510 Description Spray Gun Jar Capacity 0,26 gal Air Pressure... - Page 3 Safety Warnings for the Use of Pneumatic Tools Keep your work area clean, tidy and well lit. Use adequate personal protection. CAUTION CAUTION Cluttered and dark areas may cause accidents. Using safety glasses, anti-dust mask, safety non-skid shoes, helmet and earplugs used in adequate conditions Never use the tool in explosive environments considerably reduce the risk of injury.
- Page 4 Safety Warnings for the Use of Spray Guns Substances and Materials While operating the device CAUTION • The unit is designed to apply covering CAUTION • Never point the sprayer towards your materials like paint, varnish, enamel, etc. These should body, passersby or animals.
-
Page 5: Parts
Parts Spring Adjusting Needle Hook Nozzle Inlet Regulator Liquid Nozzle Trigger Cover Grip Suction Pipe ENGLISH... -
Page 6: Preparation
Preparation • To make a good job, it is important to prepare the surface to be sprayed. Thin the paint or product to gain the right viscosity before applying. • Always double check the surface is free of dust, dirt or grease. •... -
Page 7: Start Up
Start Up Volume Selector Start up • Turn the adjusting screw (A) in a counterclockwise • Start the compressor. direction to increase the volume of the material to be • Press the trigger (B) to open the air flow and start sprayed. -
Page 8: Maintenance
Maintenance Cleansing and Care • It is very important to clean the spray gun thoroughly after each use. WARNING An inadequate cleansing can result in malfunctioning and will cancel the Warranty. • Turn the jar to remove it from the gun. Do not remove completely. -
Page 9: Troubleshooting
• Tighten the jar. Replace the washer if • The jar is not tightened correctly or the jar damaged. washer is damaged. Imported by: Truper, S.A. de C.V. Parque Industrial No. 1, Jilotepec, C.P. 54240, Estado de México, México. Tel.: 01 (761) 782 9100 www.truper.com 03-2019... -
Page 10: Notes
Notes ENGLISH...
Need help?
Do you have a question about the PIPI-27 and is the answer not in the manual?
Questions and answers