Mitsubishi WT-46809 Owner's Manual page 27

Use of the Remote Control with Other A/V Products
VCR
CABLE/DBS/DTV DVD
TV AUDIO
1
3 DVD/LDP Player Codes
DVD/LDP brand
Code to enter:
Mitsubishi (DVD) 003
Mitsubishi (LDP) 016, 017
Panasonic 250
Pioneer DVD (LDP) 252 (016, 017)
Sony 254
Toshiba 253
To reset to default code, enter 000
Figure 4. Programming the remote to control your DVD/
LDP.
VCR
CABLE/DBS/DTV DVD
TV
AUDIO
1
3 A/V Receiver Codes
Audio brand Code to enter:
Mitsubishi A/V receiver
and/or CD player 010, 011
Kenwood 200, 208
Onkyo 209, 214
Pioneer 205, 207
Sony 222
Yamaha 201, 208
To reset to default code, enter 000
Figure 5. Programming the remote to control your A/V
receiver.
If the slide switch is set to TV when you
enter an A/V receiver code, VOLUME
and MUTE will control the A/V receiver
rather than the TV. To return volume
and mute control to the TV, set the slide
switch to TV, press and hold POWER
and enter 000.
Some manufacturers may change their
products, or they may use more than
one remote control system. If this is the
case, your remote control may not be
able to operate your VCR, DVD, cable
box, satellite receiver, or A/V receiver.
After entering the correct codes in each posi-
POWER
tion of the remote control, use the slide
2
switch to select which product will respond
when an operational button is pressed. If
you enter a code from the AUDIO chart
If your
DVD
while the slide switch is set to TV, the
code is not
listed here, volume and mute functions change to match
please see
the A/V receiver. This is useful when using
page 66
for a
an A/V receiver with the TV all the time.
complete
listing.
In all other cases, only one of the below
devices is allowed for each slide switch posi-
tion.
POWER
TV position:
2
TV
A/V receiver (volume and mute only)
Cable/DBS/DTV position:
If your
audio
Cable box
code is not
listed here, Satellite receiver
please see
DTV receiver
page 66
for a
VCR position:
complete
listing.
VCR
DVD position:
DVD
LD Player
Audio position:
A/V receiver
Mitsubishi CD player
receiver, the audio position may be used in conjunction with
select Mitsubishi CD players. Your audio position must be
programmed to either 010 or 011. Plug the CD player power
cord into a switched outlet on the back of your A/V receiver.
Pressing the POWER button will then turn on your A/V receiver,
in turn, turning on your CD player. On select CD players, the
transport controls (FF, Play, Rew, etc.) in the audio position will
operate the CD player.]
Part III: Setup
[If you have a Mitsubishi A/V
27
27