OLIGHT H1 NOVA - 500 Lumens Headlamp Manual

Table of Contents

Contents

1 INSIDE THE BOX
2 SPECIFICATIONS
3 BATTERY INSTALLATION
4 OPERATION
5 Documents / Resources
- 5.1 Download manual

INSIDE THE BOX

Headlamp (including headband and silicone mount),
Carrying Case
CR123A (3V 1600mAh)
Pocket Clip
User Manual

SPECIFICATIONS

Material: AL6061-T6 Alluminum Alloy (Body)

SPECIFICATIONS

All above specifications are test results based on ANSI/NEMA FL1-2009 Standards.
The tests are performed using one CR123A (1600mAh) Lithium battery.

BATTERY INSTALLATION

Ensure the battery is inserted with the negative (-) pointing to the head of the Headlamp (LED side).

Before first use, unscrew the tailcap and take off the insulating film.
BATTERY INSTALLATION

AVAILABLE BATTERIES

1 x CR123A or RCR123A Lithium Battery

OPERATION

BATTERY INSTALLATION
Before your first use, unscrew the tailcap and remove the insulating film within the battery compartment before screwing the tailcap back on tightly. If the battery needs to be changed, make sure that the negative polarity side of the battery faces toward the direction of the light head (the side of the LED).

ON/OFF: Single click the side switch to turn the headlamp on/off. When the headlamp is turned on again after it has been turned off, it will return to the previous mode selected before it was turned off. When the headlamp is off, SOS mode will not be memorized. The turbo mode is only memorized for 10 minutes, and after that it will only memorize the medium mode.

CHANGE BRIGHTNESS LEVEL: When the headlamp is on, press and hold the side switch to cycle through the mode sequence moonlight (or turbo) - low - medium - high - low. The mode is selected when the switch is released.

MOONLIGHT MODE: When the headlamp is off, press and hold the side switch for over one second to access the moonlight mode. If the last mode selected was moonlight before the headlamp was turned off, it will go directly to the moonlight mode once the light is turned on again.

TURBO: When the headlamp is not locked out, quickly double click the switch to activate the turbo mode. Quickly double click the side switch again to return to the previous memorized brightness level (except SOS).

SOS: When the headlamp is not locked out, quickly triple click the side switch to access the SOS mode. To quit this mode, do any operation with the switch.

LOCKOUT: When the headlamp is off, press and hold the side switch for two seconds to access the button lockout mode (the headlamp will enter the moonlight mode first and will then switch off to signal the lockout mode). Under the lockout mode, press and hold the switch for less than two seconds without releasing it and the headlamp will enter the moonlight mode again. The headlamp will quit the moonlight mode once the switch is released and it will return to and stay at the button lockout mode.

BUTTON UNLOCK: Press and hold the side switch for about two seconds until the lamp gives a single blink and then release the switch. The headlamp will unlock and will return to the moonlight mode. You can hold the switch down again from this point to start cycling through the standard modes.