Cleaning - Baldor POW'R LITE PL6000K Installation & Operating Manual

Portable light tower
Table of Contents

Advertisement

Cleaning

Keeping the light tower clean is an important part of good operation. If dirt buildup is not
removed, the light tower will run hotter than normal and it's life is reduced.
The following are general guidelines for cleaning.
Maintenance Operation
Safety Guard Inspection 
Fluid Leak Inspection − General 
Oil Level Check 
Coolant Level Check 
Fan/Alternator Belt Inspection 
Radiator Core Inspection 
Air Filter Element Check (Dry Type) 
Air Filter Check (Oil Bath Type) 
Oil Replacement − Initial only 
Oil Filter Replacement − Initial only 
Oil Replacement 
Check mast cables. Check lighting lead wires
Oil Filter Replacement
Fuel Filter Replacement
Coolant Hose Replacement
Fan/Alternator Belt Tension Adjustment
Valve Adjustment
Fan/Alternator Belt Replacement
Fuel Injection System Adjustments
Grease the mast collar grease fitting
Clean Fuel Tank 
Grease trailer bearings
Coolant Replacement
Replace Timing Belt
Add fluid(s) as needed.

After inspection, adjust, repair or replace as needed.

Clean as often as needed.

Replace air filter if air flow is restricted or one (1) year.

Service oil bath filter element (upper and lower) as needed. Replace reservoir oil as needed.

See engine manufactures recommendation.

Replace coolant every 2500 hours or 2 years.
5-2 Troubleshooting and Maintenance
1.
Clean the light tower and remove any and all dust, dirt, or other foreign material.
2.
Inspect and clean the cooling air intake and exhaust louvers of the enclosure. Make
sure they are clean. Remove dirt or any buildup that may restrict the cooling air flow.
3.
Clean the light tower and its components with a damp cloth or sponge.
Never use a water hose or pressure washer as this may damage electrical
components.
4.
Inspect and replace any control panel components that are broken or not working
properly (receptacles, circuit breakers, switches, etc.)
5.
Inspect and clean all engine linkages so they operate properly.
Maintenance Schedule
Note: In dusty conditions, service the oil bath air filter every four (4) hours of operation.
Maintenance Interval
10 Hrs
50 Hrs.
125 Hrs. 250 Hrs. 500 Hrs.
(Daily)
S
S
S
S
S
S

S
S
S
S
S
1000
Hrs.
S
S
S
S
S
S
S
S
S
S
2500
Hrs.
S
S
MN2488

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents