Table of Contents
Advertisement
These checks should be performed before first service, after 25 hours of operation and every 100
operating hours thereafter.
Trailer Checks Single axle trailer with leaf springs and two tires.
Engine/Generator Checks A 3−cylinder liquid cooled diesel engine and 4 pole, brushless, 6,000 watt generator.
Trailer Stabilization Checks Consists of 2 rear mounted outrigger assemblies and the jack on the trailer tongue.
Light Mast Checks A 4 section 30 foot mast can be rotated 360 degrees.
Light Fixtures Checks
Electrical Systems Checks
Verify that the wiring cables, switches etc. are not damaged.
3-2 Receiving & Installation
1.
Verify that the hitch mechanism on the trailer opens and closes freely and is securely
fastened to the trailer tongue.
2.
Verify that the safety chains are securely fastened to the trailer tongue.
3.
Verify that the trailer lighting connector and harness are present and are not damaged
(see Figure 3-3).
4.
Verify that tailer lights are not broken or damaged.
5.
Verify that the trailer tires are properly inflated (32 psi).
6.
Verify that the lug nuts for each wheel are properly torqued to 90 lb−ft.
7.
Verify that the enclosure is securely fastened to the trailer frame.
Ensure that all bolts, nuts and other hardware are tight and not missing.
1.
Refer to the engine manual for maintenance check procedures to ensure all fluid levels
are correct before each use.
2.
Verify that electrical receptacles, switches and circuit breakers are not damaged.
1.
Verify that the jack rotates and locks into position.
2.
Ensure that all bolts, nuts and other hardware are tight and not missing.
3.
Verify that the rear outriggers extend and rotate into position.
4.
Ensure that the lock mechanisms operate correctly.
1.
Ensure that all bolts, nuts and other hardware are tight and not missing.
2.
Verify that the cables for Tilt and Lift winches are not frayed or damaged.
3.
Verify that the Tilt and Lift winches are not damaged.
4.
Verify that the Tilt Lock and Mast Lock hardware is present and not damaged.
1.
Ensure that all bolts, nuts and other hardware are tight and not missing.
2.
Verify that the electrical cables are not frayed or damaged.
3.
Verify that the light bulbs, covers and other hardware are not damaged.
MN2488
Hide quick links:
Advertisement
Table of Contents
