The iLOQ G50S.231 and G50S.241 are battery-free programmable electromechanical cam locks for the iLOQ S50 product family in the 5 Series platform. The G50S.231 is unlocked and locked with a key and the G50S.241 is lockable without a key. Suitable for cams with a 7x7 hole and installation to a 19,2x16,2 mm hole.
English original shall apply in case of doubt. • The iLOQ G50S cylinders must be installed and used effortlessly without the use of excessive force. • Do not modify the product in any way, except in accordance with those modifications described in these instructions.
G50S Cam Lock Cylinder User Guide Basic assembly 1. Insert the lock cylinder body through the hole in the door. 16,2+0,2 19,2+0,2 2. Install and tighten the cylinder fixing nut to a torque of 8 Nm. 3. Install the latch, locking washer and latch fixing nut (3 Nm torque).
G50S Cam Lock Cylinder User Guide Assembly with the optional escutcheon and optional security nut 1. Slide the escutcheon onto the lock cylinder body. Make sure that the notch in the escutcheon is correctly aligned with the screw in the reader knob.
G50S Cam Lock Cylinder User Guide 7. Operating instructions Opening 1. Hold a valid key against the reader knob and wait until the key shows a green light. Note! Due to large variety of NFC enabled phone models and operating system versions, iLOQ...
G50S Cam Lock Cylinder User Guide Locking 7.2.1 Locking without key (G50S.241) 1. Push the door to the closed position and turn the reader knob counterclockwise to lock the door. 7.2.2 Locking with key (G50S.231) 1. Hold a valid key against the reader knob and wait until the key shows a green light.
G50S Cam Lock Cylinder User Guide 8. Replacing the reader knob If the reader knob is damaged and needs replacement knob, please follow instructions how to replace the reader knob correctly. 1. Loosen the screw on the reader knob. Use a T10 (torx) tool.
Page 11
G50S Cam Lock Cylinder User Guide 4. Tighten the screw to a torque of 1.5 Nm. Make sure that the head of the screw goes into the hole completely. A visible cap indicates that the screw is not correctly aligned with the adjustment slots in the cylinder neck.
Never discard an electrical appliance in household waste. Follow the local laws and regulations for safe and environmentally friendly product disposal. Before discarding products, bear in mind that most iLOQ products are reusable. All programmable products can be reset to factory settings, after which they can be reused in another system.
SIMPLIFIED EU DECLARATION OF CONFORMITY: Hereby, iLOQ Oy declares that the radio equipment type G50S Lock Cylinders are in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address: https://www.iloq.com/en/company/patents-and-approvals/...
Page 14
G50S Cam Lock Cylinder User Guide UKCA Hereby, iLOQ Oy declares that the radio equipment type G50S Lock Cylinders are in compliance with the UK relevant statutory requirements. The full text of the declaration of conformity is available at the following internet address: https://www.iloq.com/en/company/patents-and-approvals/...